WAM Bridge is a Windows-first Python bridge that lets you stream audio from your PC to Samsung Wireless Audio Multiroom speakers over Wi-Fi. It supports two paths: a command-line tool that serves a tokenized local stream via Samsung’s SetUrlPlayback API, and a foobar2000 output component that routes whatever foobar is playing (including internet radio) directly to your speaker.
Everything here was measured against a physical SPK-WAM550 running firmware WAM550WWB-3117.1. Other models in the Samsung WAM family are untested.
WAM Bridge is alpha software built by one person against one speaker. The CLI has hardware validation, but the later foobar2000 full-track recheck did not reproduce the older stability results. Read the test status and limitations before installing.
What works#
Stream local files and internet radio. SSDP speaker discovery, saved device aliases, custom radio stations, TuneIn preset browsing.
f32le PCM from foobar encoded to FLAC, served over local HTTP to the speaker. Passed the physical M5 checklist on 2026-08-02; stability was not reproduced in a later 2026-10-21 recheck.
Volume, mute, pause, play, stop, standby from the CLI. Hardware volume routing available for lower-latency control.
Automatic speaker discovery, UPnP renderer, Quick Settings tile, widgets, and native TuneIn browsing with artwork.
The latency note#
The last measured end-to-end FLAC latency was 6.7 seconds (historical figure, measured before the host buffer was reduced). With buffer_extra=0, the host queue is approximately 1.9 seconds. A fresh ear-to-clock measurement has not been taken yet, so the 6.7 s figure is outdated rather than current.
Earlier clean runs showed a correct host clock and seekbar, but they do not establish uninterrupted speaker playback on the current network link. Pause, stop, and skip still carry PCM pipeline latency because they act through the PCM path. Setting hardware_volume=1 routes the volume slider directly to the speaker for lower-latency volume control.
Hardware compatibility and validation#
The only speaker physically validated here is SPK-WAM550, firmware WAM550WWB-3117.1. Shape M3/M7, WAM551, R1, and some Samsung Multiroom soundbars share API evidence, not a successful WAM Bridge playback test. A SetUrlPlayback success response cannot verify audible output, timing, controls, or model-specific volume scales.
The full M5 checklist passed on 2026-08-02; a 2026-10-21 full-track recheck did not reproduce that stability on the then-current setup. Treat the earlier result as historical, not a current universal guarantee.
See the model compatibility evidence and acceptance criteria and the latest physical status.
Requirements#
CLI:
- Python 3.14+
- FFmpeg available in
PATH - Computer and speaker on the same LAN
- Windows Firewall access for the bridge on private networks
Foobar2000 component:
- Windows 10/11 and foobar2000 2.x x64
- Computer and speaker on the same LAN
- A saved WAM device profile
- No separate Python or FFmpeg installation after the component is installed; its helper bundle includes what it needs